IP Masquerading support (HAVE_FW_MASQUERADE) īuild iptunnel and ipmaddr (HAVE_IP_TOOLS) ģ. (Cisco)-HDLC/LAPB support (HAVE_HWHDLCLAPB) NET/ROM (packet radio) support (HAVE_HWNETROM) ĭLCI/FRAD (frame relay) support (HAVE_HWFR) Rose (packet radio) support (HAVE_HWROSE) Token ring (generic) support (HAVE_HWTR) ĪX25 (packet radio) support (HAVE_HWAX25) STRIP (Metricom radio) support (HAVE_HWSTRIP) SLIP (serial line) support (HAVE_HWSLIP) X.25 (CCITT) protocol family (HAVE_AFX25) Įconet protocol family (HAVE_AFECONET) ĭECnet protocol family (HAVE_AFDECnet) Įthernet (generic) support (HAVE_HWETHER) Rose (packet radio) protocol family (HAVE_AFROSE) NET/ROM (packet radio) protocol family (HAVE_AFNETROM) Novell IPX/SPX protocol family (HAVE_AFIPX) Īppletalk DDP protocol family (HAVE_AFATALK) ĪX25 (packet radio) protocol family (HAVE_AFAX25) INET6 (IPv6) protocol family (HAVE_AFINET6) INET (TCP/IP) protocol family (HAVE_AFINET) (Some configurations are turned off or on without affecting compilation success)ĭoes your system support GNU gettext? (I18N) Turn off the x.25 and other related configurations, otherwise the compilation will report an error. After decompression, enter the net-tools-1.60/directory, execute: make config for configuration ypdomainname is the same as domainname.Ģ.
Slattach corresponds to a certain network interface as a serial line, for example, adding a common terminal line as a certain network mode.route is used to manage the IP routing table.The rarp command is similar to the arp command and processes the RARP (Reverse Address Resolution Protocol) table of the operating system.plipconfig is used to optimize the parameters of the PLIP device to speed up the device.nisdomainname is the same as domainname.netstat can display information such as network connections, routing lists, interface status, and virtual connections.nameif names the network interface based on the MAC address.ifconfig is used to configure the network interface.hostname is used to set or display the host name of the system.domainname displays the NIS/YP domain name of the system.dnsdomainname displays the DNS domain name of the system.arp is used to operate the core ARP (Address Resolution Protocol) cache, usually used to add, delete an entry and dump the ARP cache.
Install the following programs: arp, dnsdomainname (link to hostname), domainname (link to hostname), hostname, ifconfig, nameif, netstat, nisdomainname (link to hostname), plipconfig, rarp, route, slattach and ypdomainname (link to hostname)
Net-tools contains a series of programs that form the basis of Linux networking.